 |
 |
|
Holzma's HCL 11 & HFL 11 Rear-Loading Angular Panel Saws are designed for
the volume production environment. They feature an independent ripcut saw and a
crosscut saw in the same unit.
complete our online request form
or call Bill Pitt at 704.861.8239.
|
|
features
• Head cut capability - standard
• Automatic turning device - presents each side of the panel
• Automatic panel feeding - individually or by book
• Micro infeeds - cut thin or wavy panels
|
|
 |
|
Holzma's HFL 33 Rear-Loading Angular Panel Saw is designed for the high-volume
production environment. It features an independent ripcut saw and a crosscut
saw in the same unit and automatic material handling between the two. This
allows up to three different cutting patterns to be run simultaneously.
complete our online request form
or call Bill Pitt at 704.861.8239.
|
|
features
• Head cut capability - standard
• Automatic turning device - presents each side of the panel
• Automatic panel feeding - individually or by book
• Micro infeeds - cut thin or wavy panels
|
|
 |
|
Holzma's HFL 66 Rear-Loading Angular Panel Saw is designed for the volume
production environment. It features an independent ripcut saw and a crosscut
saw in the same unit.
To achieve high throughput, each saw carriage has a scoring saw and motor, a
primary main saw and motor, and a secondary main saw and motor. The primary saw
cuts the bottom half of the book, while the secondary saw, which has a slightly
wider kerf, cuts the balance. Since neither saw cuts the full load, it is
possible to cut much faster than a single saw system.
complete our online request form
or call Bill Pitt at 704.861.8239.
|
|
features
• Head cut capability - standard
• Automatic turning device - presents each side of the panel
• Automatic panel feeding - individually or by book
• Micro infeeds - cut thin or wavy panels
|
|
 |
|
Holzma's HKL 11 is a brand new angular plant cut up
system.
complete our online request form
or call Bill Pitt at 704.861.8239.
|
|
features
• 4300mm ripping capability
• 2200mm crosscutting capability
• Holzma micro-feed thin panel infeed system
• User-friendly CADmatic 3.0 control
• Intermediate buffer storage table between the rip saw and crosscut saw
to insure that both saws work concurrently
• Dynamic rack and pinion drives for program fences and saw carriages
• Touch-free, magnetic measuring system for tight tolerance measurement
functions; impervious to dust and mechanical wear
• Standard built-in head cut capability to make the most efficient use of
expensive panels
|
